The Xtar T1 is a lightweight, rechargeable key ring flashlight that has a maximum output of 500 lumens primary white light from a Cree XP-G3 LED and also features a side panel with auxiliary light outputs.

The first auxiliary output offers a red, blue light and green light with multiple outputs via the RGB LED chip located on the body of the torch. The single red, green or blue light can be used as a location indicator to mark a spot or used along with a warning triangle at the road side, while the alternating flashing lights act as a warning signal to attract attention which is useful in an emergency. The second auxiliary output is an ultraviolet LED with a wavelength of 395~400 nm, which is useful for a range of tasks including detecting fraudulent money and ID cards as well as verification mark reading, UV ink reading, Smart Water and SelectaDNA.

Five main white brightness levels are available, as well as the aux settings and strobe, all of which are controlled by a single push button. To access the main white output, single press the button to turn the light on and then single press to cycle through moonlight, low, mid, high, strobe and hold the button to turn the light off. Momentary access to turbo is possible by holding the button down while the light is off, and will turn off once the button is released or automatically after 30 seconds to prevent overheating.

Double press the button from off to access the RGB auxiliary settings and then single press to cycle through red, green, blue, flashing red/blue, alternating red/green/blue, red flash and hold the button down to turn the light off. In either white or RGB mode the last used setting will be recalled next time the light is turned back on in that mode (excluding strobe). Triple press the button to access the aux UV light, and hold the button to turn it off.

The integrated rechargeable lithium polymer battery is charged via a USB-C charging port on the side of the torch for fast charging and once connected to a power USB power source using the included short cable a charging indicator under the switch will illuminate red to show charging is in progress, and turn green once charging is complete after approximately 30 minutes.

A solid ring pull design allows for attachment of keys using the included carabiner style key ring clip.

• Operational Modes
• Moonlight: 2 lumen; 4 hours, 3 minutes run-time
• Low: 50 lumens; 1 hour, 49 minutes run-time
• Mid: 150 lumens: 52 minutes run-time
• High: 300 lumens; 19 minutes run-time
• Turbo: 500 lumens; 9 minutes*
• Red: 6 lumens; 43 minutes run-time
• Green: 7 lumens; 52 minutes run-time
• Blue: 5 lumens; 37 minutes run-time
• Ultraviolet: 3 lumens; 29 minutes run-time
• Note: *This is an accumultive run-time as the turbo can only be used in 30 seconds bursts to prevent overheating.
• Operating Modes: Moonlight / Low / Mid / High / Trubo / Strobe / Red / Blue / Green / UV
• Luminous Flux: Up to 500 lumens (main light)
• Lamp Type: 1 x white CreeXP-G3 LED / 1 x Red LED / 1 x Blue LED / 1 x Green LED / 1 x UV LED
• UV wavelength: 395~400 nm
• Batteries Required: Built-in lithium polymer battery
• Charging time: 30 minutes
• Overall Length: 57.6 mm
• Head Diameter: 15.8 mm
• Weight: 18.5 grams
• Body Colour: Black
• Body Material: Aluminium alloy
• Impact Resistance: 1.5 m
• Packaging and Contents
• Supplied in retail packaging and includes:
• Xtar T1 LED key ring torch x 1
• USB-C to USB-A charging cable x 1
• Key ring x 1